 |
 |
|
 ACCESSORIES |
The accessories section contains all Omni-site accessories and promotional items that can be used with the XR50+ and Crystal Ball+. Not all accessories can be used with both products though, please verify with your local rep to see if a particular accessory is compatitable with your RTU.
|
|
| Omni-site does not do direct sales. If you are interested in buying an Omni-site product, please contact your local representative for pricing.
|
|
|
|
Submersible Well Level Transmitter -
When a highly precise ceramic pressure sensor with long-term stability for reliable and safe water measurement is required, the rope probe from Omni-site is the solution.
The I-Level Submersible Well Level Transmitter is an economical hydrostatic pressure sensor with an external diameter of 22mm. The dry measuring cell with its robust ceramic diaphragm is extremely
resistant to mechanical influences like abrasion. The measuring device outputs a 4-20 mA signal.
Omni-site.net part # I-Level
Slip-on Amp Probes - The Slip-on amp probe is a must if you want to monitor pump runtimes with the Crystal Ball. The slip-on amp probes
can be used to directly monitor up to 200 amps and output a 4-20 mA signal. The probes come standard in a spilt core design that allows
for easy installation of the transducer on existing wiring. It is small sized and loop powered.
Omni-site.net part # SPAP/A200
Current Switch -
The current switch is designed to replace your relays so that you can accurately and quickly wire up pump runtime counters. This model comes in a solid core version, which can monitor from 1 to 250 amps. The sensor has a digital output to monitor an "on" or "off" state of your pumps.
Omni-site.net part # CS
Rain Collector -
The Rain Gauge is a tipping bucket style rain collector. Once the rain gauge measures .01" of rain the gauge will tip and close the contact closure. The enclosure is made of a UV-stabilized ABS plastic. A heater can be purchased, for cold weather conditions.
Omni-site.net part # RAIN-01
Solar Kit - For those "hard to
reach" applications where power is not available, this system can provide
alarm monitoring where others cannot. The kit includes a solar module, a pre-wired voltage regulator with output
cable, and a fixed tilt, 45" side-of-pole mount. The XR50+ or Crystal Ball+, battery, antenna and cable sold
separately. You can be activated, installed,
and operating in remote locations in just hours, instead of days, weeks,
or months. Perfect for monitoring combined sewer overflows
(CSOs).
Omni-site.net part#
S0LAR
Polycarbonate Enclosure -
The Polycarbonate box 12" x 10" x 4" and is NEMA 4X rated. Should be used when the XR50+ or Crystal Ball+ needs to be mounted outside or when more protection is needed in indoor applications. The Omni-site RTU comes pre-mounted on a backplate in the enclosure and the antenna is pre-wired and mounted on the box. The box has (2) 3/4" conduit knockouts for easy wiring without drilling. Comes with either a solid or clear cover.
Omni-site.net part # EN
Intelligent Key -
The Intelligent Personal Identification Key when used with the unit, will give the customer the ability to identify who serviced the equipment and at what time!
Omni-site.net part # KEY
Lightning Arrestor - Just in case the need arises for a little extra protection against power surges and
lightning we offer the Lightning Arrestor. The power line protector is soldered in place and incorporated within the equipment and
also ground referenced to the equipment. Features 1-3/4" leads and both solid state and gas tube protection methods. The ease of installation and great protection makes this product a
great buy.
Omni-site.net part # LA-001
Conduit Kit -
The kit includes (4) 3/4" conduit fittings, (1) 8' length of sealtite conduit and (1) 12' strand of 8 conductor 16 AWG wire so you can quickly install either the XR50+ or Crystal Ball+ unit. The kit will eliminate multiple trips out to the job site.
Omni-site.net part # CONDUIT
 Low
Visibility, Permanent Mount Antenna - If you are adding our XR50+
Micro RTU or Crystal Ball+ to an existing equipment panel or you are an OEM panel builder,
then you may want to consider using our "Phantom" 3 dB secure mount,
low-profile antenna. It mounts through the top of an electrical enclosure
using a very secure 7/8 mounting stud, and is connected to the Omni-site RTU
using a short coax jumper cable (please specify jumper cable length). It
is a low-visibility, wide bandwidth, and low angle radiation pattern unit
that can produce superior results to many high-gain antennas.
This antenna is great in areas where vandalism is a concern, as it does not
look much like an antenna so it is not likely to be tampered with and cannot be removed.
Omni-site.net part # Phantom
Coax Cable - The cable is a solid center RG58 made of solid polyethlene dielectric. The shield percentage
is 95% braid. The cable can be used with both phantom and yagi antennas. The standard cable is 2 feet long.
Please specify length of cable for any other size.
Omni-site.net part# CABLE-2
External Connector -
The external connector is used when you need to run an extended coax cable from the polycarbonate enclosure to an externally mounted antenna. The "EC" will fill the hole left by the antenna and serve as a connector from the RTU to the coax cable.
Omni-site.net part # EC
Yagi Antenna - Our Yagi antenna is a 2.33 foot, 9
dB directional gain antenna. The antenna is made of solid elements mounted through
boom for long life. The Yagi is the strongest antenna Omni-site offers. Use the Yagi
antenna for applications were the signal strength in the area is known to be weak. The
Yagi antenna will improve signal strength by several dB levels.
Omni-site.net part # YAGI
SD Card -
The Secure Digital "SD" card is used to add extra memory to the Crystal Ball+ and XR50+ or to re-program the unit. This type of flash memory can commonly be found in digital cameras, MP3 players and Palm Pilots.
Omni-site.net part # SD-CARD
 Replacement Crystal Ball Battery -
Sure we could use a bigger battery, but why? These 12V, 0.8AH batteries can provide up to 6 hours of battery
backup in case of power outages, and they are low priced. After the original crystal ball battery goes through its service life, this will be the perfect
replacement. Service life rated at 3-5 years.
Omni-site.net part # BattCB
Replacement Solar Battery -
The replacement battery is a 12 Volt 12 Amp Hour battery that can be used to replace the solar panel battery. The expected battery life is 3-5 years. Works with both Omni-site RTU's.
Omni-site.net part # BATT12120
OPC Tunneller Package -
With the OPC Tunneller Package you can have your data sent directly to your existing Wonderware / Intellution (or any other OPC Product) installation. This allows either the XR50+ or Crystal Ball+ to integrate into your existing SCADA package.
Omni-site.net part # OPC
Omni-site Mouse Pad -
What better way to keep the Omni-site name on your customers' minds than by passing out the Omni-site Mouse pad.
The Omni-site mouse pad on your desk will brighten your day. This is not your ordinary cheap mouse pad, either;
it's made of durable and reliable materials to outlast other mouse pads and probably even your computer.
Omni-site.net part # MPAD
Omni-site Camo Hat -
Keep Omni-site on your mind and on your head with the Omni-site camo hat. Wear the Omni-site logo proudly in this 6 panel quality made hat. These hats are built
to last. Comes in two styles: Advantage Timber and Acorn Trail.
Omni-site.net part # CAMO
|
|
|
 |
 |
